2012 Revised Wind Mitigation Inspection Form

On December 6, 2011, proposed revisions to Rule 690-170.0155, Florida Administrative Code, was approved by the Florida Service Commission. The rule incorporated and adopted revisions to the Uniform Mitigation Verification Inspection Form.

The new form is OIR-B1-1802 (Rev.01/12), and is effective February 1, 2012.
Wind Mitigation Inspections and re-inspections on or after the 1st of February will be required to use this more detailed form. The new form comes with various changes that require the Inspector to use more due diligence when conducting the inspection, and report more details of components then the previous version.

Since the new form requires inspectors to conduct more research about the roof materials and property permits, it is in the homeowner’s best interest to have proper documentation available. Documentation such as, but not limited to: permits for shutters, and either a new roof or re-roof, and Notice of Acceptance (NOA) for Exterior Opening Protection.

Some form changes allow for discounts that homeowners would not have qualified for on the previous form. For example, the separation of high impact windows from all other entrances (i.e. garage) may qualify for extra discounts.

Some other helpful tips for home owners are:
Inspect your homes windows or your records to determine when they were installed.

Your records and window labels should have product approval codes that may indicate whether they are impact-resistant. Look for these codes: SSTD12; ASTME 1886 and ASTM E 1996; or Miami-Dade Protocols TAS 201, TAS 202, TAS 203.

If you have permanent or temporary shutters or panels, inspect them and your records to determine if they are impact resistant. Look for codes: SSTD12; ASTM E 1886 and ASTM E 1996; or Miami-Dade Protocols TAS 201, TAS 202, TAS 203. Make sure they are working properly and have a secure fit.

Wind Mitigations Inspections still remain a valuable tool for Home Owners looking to save on Insurance premiums by obtaining discounts.

This entry was posted in Industry Articles. Bookmark the permalink.

Comments are closed.